Host PC to PMC Connection

Connect the PMC to the host PC using the M12-8-pin to RJ45 cable, as shown in the picture below.

Open

At this step,

1. Make sure the power supplies for Flyways and the PMC are off.

2. Check the wiring for the PMC and Flyways according to Electrical Setup.

3. Connect the PMC to the host PC using the M12-RJ45 cable

4. Turn on the power to the Flyways and PMC.

5. Wait until the PMC Status LED turns solid green or flashing green, this may take up to 2 minutes. 

Open

The PMC Status LED is located next to the PMC power input port. The LED colour and meaning are listing in the table below.